uu.seUppsala University Publications
Change search
Link to record
Permanent link

Direct link
BETA
Axelsson, Maria
Publications (10 of 10) Show all publications
Axelsson, M. (2008). Tracking Tubular Structures in Volume Image Data. In: Proceedings SSBA 2008: Symposium on Image Analysis, Lund, March 12-14, 2008 (pp. 51-54).
Open this publication in new window or tab >>Tracking Tubular Structures in Volume Image Data
2008 (English)In: Proceedings SSBA 2008: Symposium on Image Analysis, Lund, March 12-14, 2008, 2008, p. 51-54Conference paper, Published paper (Other academic)
National Category
Computer and Information Sciences
Identifiers
urn:nbn:se:uu:diva-15912 (URN)
Available from: 2008-03-16 Created: 2008-03-16 Last updated: 2018-01-12Bibliographically approved
Axelsson, M., Svensson, S. & Borgefors, G. (2007). 2D Ring Artifact Reduction of X-ray Tomography Images. In: Proceedings SSBA 2007: Symposium on Image Analysis, Linköping, March 14-15.
Open this publication in new window or tab >>2D Ring Artifact Reduction of X-ray Tomography Images
2007 (English)In: Proceedings SSBA 2007: Symposium on Image Analysis, Linköping, March 14-15, 2007Conference paper, Published paper (Other scientific)
Identifiers
urn:nbn:se:uu:diva-11266 (URN)
Available from: 2007-08-21 Created: 2007-08-21
Axelsson, M. (2007). 3D Tracking of Cellulose Fibres in Volume Images. In: IEEE International Conference on Image Processing, 2007. ICIP 2007. (pp. IV-309).
Open this publication in new window or tab >>3D Tracking of Cellulose Fibres in Volume Images
2007 (English)In: IEEE International Conference on Image Processing, 2007. ICIP 2007., 2007, p. IV-309Conference paper, Published paper (Refereed)
Abstract [en]

Segmentation of individual fibres in volume images is important when analysing the three dimensional (3D) fibre structure in paper and cellulose based composite materials. This paper presents a novel method for 3D tracking of individual fibres which can be used as a pre-segmentation step to a full cell wall segmentation or be used to estimate the fibre orientation. The tracking starts in one seed in each fibre and automatically extracts the local fibre orientation and the fibre centre point in each step using 3D information. Good results are obtained for cellulose fibres that are partially collapsed, cracked or irregularly shaped. The proposed method can also be used in other applications where tracking of tubular structures is of interest.

National Category
Computer and Information Sciences
Identifiers
urn:nbn:se:uu:diva-12171 (URN)10.1109/ICIP.2007.4380016 (DOI)978-1-4244-1437-6 (ISBN)
Available from: 2007-12-04 Created: 2007-12-04 Last updated: 2018-01-12Bibliographically approved
Nygård, P., Gradin, P., Gregersen, Ø., Lindblad, J., Axelsson, M., Svensson, S., . . . Borgefors, G. (2006). Damage Mechanisms in Paper. In: 2006 Progress in Paper Physics.
Open this publication in new window or tab >>Damage Mechanisms in Paper
Show others...
2006 (English)In: 2006 Progress in Paper Physics, 2006Conference paper, Published paper (Other academic)
National Category
Engineering and Technology
Identifiers
urn:nbn:se:uu:diva-21712 (URN)
Available from: 2007-01-03 Created: 2007-01-03 Last updated: 2018-08-24Bibliographically approved
Axelsson, M., Chinga, G., Svensson, S., Nygård, P., Malmberg, F., Solheim, O., . . . Borgefors, G. (2006). Detailed quantification of the 3D structure of newsprints in X-ray synchrotron radiation microtomography images. In: Progress in Paper Physics Seminar, Oxford, Ohio, 2006.
Open this publication in new window or tab >>Detailed quantification of the 3D structure of newsprints in X-ray synchrotron radiation microtomography images
Show others...
2006 (English)In: Progress in Paper Physics Seminar, Oxford, Ohio, 2006, 2006Conference paper, Published paper (Other academic)
National Category
Engineering and Technology
Identifiers
urn:nbn:se:uu:diva-18446 (URN)
Available from: 2006-12-21 Created: 2006-12-21 Last updated: 2018-08-24Bibliographically approved
Axelsson, M., Östlund, C., Vomhoff, H. & Svensson, S. (2006). Estimation of the pore volume at the interface between paper web and press felt. Nordic Pulp & Paper Research Journal, 21(3), 395-402
Open this publication in new window or tab >>Estimation of the pore volume at the interface between paper web and press felt
2006 (English)In: Nordic Pulp & Paper Research Journal, ISSN 0283-2631, E-ISSN 2000-0669, Vol. 21, no 3, p. 395-402Article in journal (Refereed) Published
Abstract [en]

A method for determining the water content at the interface between a press felt and a paper web has been developed. The water content was obtained by subtracting the estimated volume of the indented fibre web from the measured felt surface porosity of the press felt. The felt surface porosity was calculated from a topography map that was imaged with a Confocal Laser Scanning Microscope (CLSM) method. Here, the press felt was compressed against a smooth surface using a stress in the range of 0 to 10 MPa. Artefacts in the CLSM images were reduced using an image analysis method. The indentation of paper webs into the measured felt surface pores at different applied pressures was estimated using another image analysis method, simulating a rolling ball, with different radii of curvature for the different pressures and grammages, rolling over the felt surface. The ball radii were determined for a low and a high grammage web using the STFI-Packforsk Dewatering model. The method was evaluated in a case study with four press felts that had batt fibre diameters in a range between 22 and 78 μm. The indentation was calculated for webs with a low (15 g/m2) and a high grammage (105 g/m2), respectively. The evaluation showed that a considerable amount of porespace is available at the interface between the web and the felt. In most cases, the volume of the water-filled pores accounted for approximately 50% of the total surface porosity of the felt. Assuming a complete water saturation of the web/felt interface, approximately 10 g/m2 of water for the finest felt surface up to 40 g/m2 for the coarsest felt surface, could be located at the interface between the press felt and the paper web at a load of 10 MPa. This implies that a considerable amount of water is available for separation rewetting.

Keywords
press felt, surface porosity, pore volume estimation, image analysis, CLSM, compression device
National Category
Computer Vision and Robotics (Autonomous Systems)
Identifiers
urn:nbn:se:uu:diva-18439 (URN)000241531500015 ()
Available from: 2006-12-21 Created: 2006-12-21 Last updated: 2018-01-12Bibliographically approved
Axelsson, M., Svensson, S. & Borgefors, G. (2006). Reduction of Ring Artifacts in High Resolution X-Ray Microtomography Images. In: Pattern Recognition: 28th DAGM Symposium, Berlin, Germany, September 2006, Proceedings (pp. 61-70).
Open this publication in new window or tab >>Reduction of Ring Artifacts in High Resolution X-Ray Microtomography Images
2006 (English)In: Pattern Recognition: 28th DAGM Symposium, Berlin, Germany, September 2006, Proceedings, 2006, p. 61-70Conference paper, Published paper (Refereed)
Abstract [en]

Ring artifacts can occur in reconstructed images from X-ray microtomography as full or partial circles centred on the rotation axis. In this paper, a 2D method is proposed that reduces these ring artifacts in the reconstructed images. The method consists of two main parts. First, the artifacts are localised in the image using local orientation estimation of the image structures and filtering to find ring patterns in the orientation information. Second, the map of the located artifacts is used to calculate a correction image using normalised convolution. The method is evaluated on 2D images from volume data of paper fibre imaged at the European Synchrotron Radiation Facility (ESRF) with high resolution X-ray microtomography. The results show that the proposed method reduces the artifacts and restores the pixel values for all types of partial and complete ring artifacts where the signal is not completely saturated.

Series
Lecture notes in computer science, ISSN 0302-9743 ; 4174
National Category
Computer Vision and Robotics (Autonomous Systems)
Identifiers
urn:nbn:se:uu:diva-18443 (URN)10.1007/11861898_7 (DOI)978-3-540-44412-1 (ISBN)
Available from: 2006-12-21 Created: 2006-12-21 Last updated: 2018-01-12Bibliographically approved
Bogren, K., Gamstedt, K., Berthold, F., Lindström, M., Nygård, P., Malmberg, F., . . . Borgefors, G. (2006). Stress transfer and failure in pulpfibre reinforced composites: Effects of microstructure characterized by Xray microtomography. In: 2006 Progress in Paper Physics: A seminar.
Open this publication in new window or tab >>Stress transfer and failure in pulpfibre reinforced composites: Effects of microstructure characterized by Xray microtomography
Show others...
2006 (English)In: 2006 Progress in Paper Physics: A seminar, 2006Conference paper, Published paper (Other academic)
National Category
Computer and Information Sciences
Identifiers
urn:nbn:se:uu:diva-21711 (URN)
Available from: 2007-01-03 Created: 2007-01-03 Last updated: 2018-08-24Bibliographically approved
Axelsson, M., Östlund, C., Vomhoff, H. & Svensson, S. (2006). Volume estimation of the interface pores between paper web and press felt. In: Proceedings SSBA 2006: Symposium on Image Analysis.
Open this publication in new window or tab >>Volume estimation of the interface pores between paper web and press felt
2006 (English)In: Proceedings SSBA 2006: Symposium on Image Analysis, 2006Conference paper, Published paper (Other academic)
National Category
Computer and Information Sciences
Identifiers
urn:nbn:se:uu:diva-21713 (URN)
Available from: 2007-01-03 Created: 2007-01-03 Last updated: 2018-01-12Bibliographically approved
Axelsson, M., Sintorn, I.-M., Svensson, S. & Borgefors, G. (2005). Individual pore segmentation in 3D volumes of fibrous materials. In: SSBA Symposium on Image Analysis 2005.
Open this publication in new window or tab >>Individual pore segmentation in 3D volumes of fibrous materials
2005 (English)In: SSBA Symposium on Image Analysis 2005, 2005Conference paper, Published paper (Other scientific)
Identifiers
urn:nbn:se:uu:diva-74499 (URN)
Available from: 2005-10-03 Created: 2005-10-03
Organisations

Search in DiVA

Show all publications