uu.seUppsala universitets publikasjoner
Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Heavy-Ion Induced Desorption of a TiZrV Coated Vacuum Chamber Bombarded with 5 MeV/u Ar8+ beam at grazing incidence
Uppsala universitet, Teknisk-naturvetenskapliga vetenskapsområdet, Fysiska sektionen, Institutionen för fysik och astronomi, Kärn- och partikelfysik.
Uppsala universitet, Teknisk-naturvetenskapliga vetenskapsområdet, Fysiska sektionen, Institutionen för fysik och materialvetenskap.
Vise andre og tillknytning
2009 (engelsk)Inngår i: Journal of Vacuum Science & Technology. A. Vacuum, Surfaces, and Films, ISSN 0734-2101, E-ISSN 1520-8559, Vol. 27, nr 1, s. 139-144Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

TiZrV nonevaporable getter (NEG) coated vacuum chambers is a new vacuum technology which is already used in many particle accelerators worldwide. This coating is also of interest for heavy-ion accelerator vacuum chambers. Heavy-ion desorption yields from an activated as well as a CO saturated NEG coated tube have been measured with 5 MeV/u Ar8+ beam. The sticking probability of the NEG film was obtained by using the partial pressure ratios on two sides of the NEG coated tube. These ratios were compared to results of modeling of the experimental setup with test particle Monte Carlo and angular coefficient methods. The   partial pressures inside the saturated NEG coated tube bombarded with heavy ions were up to 20 times larger than those inside the activated one. However, the partial pressure of methane remained the same. The value of the total desorption yield from the activated NEG coated tube is 2600 molecules/ion. The desorption yields after saturation for CH4, H-2, and CO2 were found to be very close to the yields measured after the activation, while CO increased by up to a factor of 5. The total desorption yield for the saturated tube is up to 7000 molecules/ion. The large value of the desorption yield of the activated NEG coated   tube, an order of magnitude higher than the desorption yield from a stainless steel tube at normal incident angle, could be explained by the grazing incident angle.

sted, utgiver, år, opplag, sider
2009. Vol. 27, nr 1, s. 139-144
Emneord [en]
carbon compounds, desorption, hydrogen, ion beam effects, metallic thin films, Monte Carlo methods, titanium alloys, vanadium alloys, zirconium alloys
HSV kategori
Identifikatorer
URN: urn:nbn:se:uu:diva-97077DOI: 10.1116/1.3032914ISI: 000264017300019OAI: oai:DiVA.org:uu-97077DiVA, id: diva2:171863
Tilgjengelig fra: 2008-04-18 Laget: 2008-04-18 Sist oppdatert: 2017-12-14bibliografisk kontrollert
Inngår i avhandling
1. Studies of Heavy Ion Induced Desorption in the Energy Range 5-100 MeV/u
Åpne denne publikasjonen i ny fane eller vindu >>Studies of Heavy Ion Induced Desorption in the Energy Range 5-100 MeV/u
2008 (engelsk)Doktoravhandling, med artikler (Annet vitenskapelig)
Abstract [en]

During operation of heavy ion accelerators a significant pressure rise has been observed when the intensity of the high energy beam was increased. The cause for this pressure rise is ion induced desorption, which is the result when beam ions collide with residual gas molecules in the accelerator, whereby they undergo charge exchange. Since the change in charge state will affect the bending radius of the particles after they have passed a bending magnet, they will not follow the required trajectory but instead collide with the vacuum chamber wall and gas are released. For the Future GSI project FAIR (Facility for Antiproton and Ion Research) there is a need to upgrade the SIS18 synchrotron in order to meet the requirements of the increased intensity. The aim of this work was to measure the desorption yields, η, (released molecules per incident ion) from materials commonly used in accelerators: 316LN stainless steel, Cu, Etched Cu, gold coated Cu, Ta and TiZrV coated stainless steel with argon and uranium beams at the energies 5-100 MeV/u. The measurements were performed at GSI and at The Svedberg Laboratory where a new dedicated teststand was built. It was found that the desorption yield scales with the electronic energy loss to the second power, decreasing for increasing impact energy above the Bragg Maximum. A feasibility study on the possibility to use laser refractometry to improve the accuracy of a specific throughput system was performed. The result was an improvement by up to 3 orders of magnitude, depending on pressure range.

sted, utgiver, år, opplag, sider
Uppsala: Acta Universitatis Upsaliensis, 2008. s. 65
Serie
Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, ISSN 1651-6214 ; 425
Emneord
Physics, Heavy Ion Induced Desorption, Ultra High Vacuum, NEG Coating, Heavy Ion Accelerators, Test Particle Monte-Carlo, Gas Flow, Throughput, Laser Refractometry, Metrology, Fysik
Identifikatorer
urn:nbn:se:uu:diva-8654 (URN)978-91-554-7168-2 (ISBN)
Disputas
2008-05-09, Siegbahnsalen, Ångströmlaboratoriet, Lägerhyddsvägen 1, Uppsala, 09:15
Opponent
Veileder
Tilgjengelig fra: 2008-04-18 Laget: 2008-04-18bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekst
Av organisasjonen
I samme tidsskrift
Journal of Vacuum Science & Technology. A. Vacuum, Surfaces, and Films

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 671 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf