uu.seUppsala University Publications
Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Quantification of Buserelin in a Pharmaceutical Product by Multiple-injection CZE
Uppsala University, Disciplinary Domain of Medicine and Pharmacy, Faculty of Pharmacy, Department of Medicinal Chemistry, Analytical Pharmaceutical Chemistry.
Uppsala University, Disciplinary Domain of Medicine and Pharmacy, Faculty of Pharmacy, Department of Medicinal Chemistry, Analytical Pharmaceutical Chemistry.
2007 (English)In: Electrophoresis, ISSN 0173-0835, E-ISSN 1522-2683, Vol. 28, no 10, 1548-1556 p.Article in journal (Refereed) Published
Abstract [en]

An efficient and rapid separation method based on reversed-polarity multiple-injection CZE (MICZE), has been developed for the quantification of buserelin in a pharmaceutical product. The determinations were performed by serially injecting five standard solutions of buserelin (50-300 μug/mL) and one reference analyte into a Polybrene-coated capillary. All the samples contained goserelin, an analog peptide to buserelin, as internal standard (IS). Immediately after pressure injection, the applied sample plugs were subjected to electrophoresis for 2 min at -25 kV. Consequently, each sample plug became isolated from its neighboring plugs by the BGE, composed of 100 mM phosphate-triethanolamine buffer at pH 3.0 containing 10% v/v ACN. During separation the individual sample components migrated at similar velocities and as distinct zones through the capillary giving 24 peaks, 12 from the analyte and the IS and 12 from the sample matrix. The buserelin content of the pharmaceutical product was determined to be 0.94 ± 0.05 mg/mL, which is only a slight deviation from the declared concentration (1 mg/mL).

Place, publisher, year, edition, pages
2007. Vol. 28, no 10, 1548-1556 p.
Keyword [en]
Buserelin, Multiple injection, Peptides, Polybrene, Quantitative analysis
National Category
Pharmaceutical Sciences
Identifiers
URN: urn:nbn:se:uu:diva-97251DOI: 10.1002/elps.200600636ISI: 000246923300012PubMedID: 17447243OAI: oai:DiVA.org:uu-97251DiVA: diva2:172108
Available from: 2008-05-14 Created: 2008-05-14 Last updated: 2017-12-14Bibliographically approved
In thesis
1. Separation of Pharmaceuticals by Capillary Electrophoresis using Partial Filling and Multiple-injections
Open this publication in new window or tab >>Separation of Pharmaceuticals by Capillary Electrophoresis using Partial Filling and Multiple-injections
2008 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Different multiple-injection methodologies and the partial filling technique (PFT) have been utilized for separation of pharmaceuticals by capillary elec-trophoresis.

In multiple-injection capillary zone electrophoresis (MICZE), the samples and all standards, used for construction of the calibration curve, are analyzed within a single run. Four different modes of MICZE have been described by means of equations, which were experimentally verified. The developed equations facilitate the transfer from conventional single-injection CZE to one or more of these MICZE-modes, depending on the selectivity between the analyte and the injection marker. The applicability of two of these modes was then demonstrated by quantification of buserelin and salbutamol, re-spectively in commercially available pharmaceutical products. The content of buserelin in an injection solution was determined to 0.94 mg/ml, which only deviated slightly from the declared concentration (1 mg/ml). An alter-native mode of MICZE, offering a higher number of sequential sample injec-tions, was then utilized for single-run determination of salbutamol in 15 tab-lets, with a labelled content of 8 mg. The average content of the tablets was determined to 7.8 mg, with an intra-tablet variation of 3 % or less.

Moreover, UV- and mass-spectrometric detection of enantiomeric amines, resolved by non-aqueous capillary electrophoresis (NACE), was demon-strated. Separation of enantiomeric amines was achieved using the chiral selector (-)-2,3:4,6-di-O-isopropylidene-2-keto-L-gulonic acid, (-)-DIKGA. Introduction of the non-volatile (-)-DIKGA into the mass-spectrometer was avoided by using the PFT, where the capillary is only partially filled with electrolyte containing the chiral selector.

Place, publisher, year, edition, pages
Uppsala: Acta Universitatis Upsaliensis, 2008. 60 p.
Series
Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Pharmacy, ISSN 1651-6192 ; 75
Keyword
Capillary Coating, Chiral Separation, Enantiomers, Mass-spectrometric Detection, Method Validation, Multiple-injection Capillary Zone Electrophoresis, Non-aqueous Capillary Electrophoresis, Organic Solvents, Pharmaceutical Analysis, Quantitative Analysis
Identifiers
urn:nbn:se:uu:diva-8841 (URN)978-91-554-7211-5 (ISBN)
Public defence
2008-06-05, B41, BMC, Husargatan 3, Uppsala, 13:15
Opponent
Supervisors
Available from: 2008-05-14 Created: 2008-05-14 Last updated: 2011-01-28Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full textPubMed

Authority records BETA

Lodén, HenrikAmini, Ahmad

Search in DiVA

By author/editor
Lodén, HenrikAmini, Ahmad
By organisation
Analytical Pharmaceutical Chemistry
In the same journal
Electrophoresis
Pharmaceutical Sciences

Search outside of DiVA

GoogleGoogle Scholar

doi
pubmed
urn-nbn

Altmetric score

doi
pubmed
urn-nbn
Total: 482 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf