uu.seUppsala University Publications
Change search
ReferencesLink to record
Permanent link

Direct link
In vivo evaluation of an injectable premixed radiopaque calcium phosphate cement International Journal of Biomaterials
Uppsala University, Disciplinary Domain of Science and Technology. Uppsala University, Disciplinary Domain of Science and Technology, Faculty of Science and Technology. Uppsala University, Disciplinary Domain of Science and Technology, Technology, Department of Engineering Sciences, Applied Materials Sciences. (Materials in Medicine)
Show others and affiliations
(English)In: International Journal of BiomaterialsArticle in journal (Refereed) Submitted
Keyword [en]
premixed, calcium phosphate cement, in vivo, radiopacity, zirconia
National Category
Engineering and Technology
Research subject
Materials Science
URN: urn:nbn:se:uu:diva-138451OAI: oai:DiVA.org:uu-138451DiVA: diva2:379306
Available from: 2010-12-17 Created: 2010-12-17 Last updated: 2012-03-29Bibliographically approved
In thesis
1. Premixed Acidic Calcium Phosphate Cements
Open this publication in new window or tab >>Premixed Acidic Calcium Phosphate Cements
2012 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Calcium phosphate cements are used in medicine to fill bone defects or give support to screws and plates in fracture fixation. The cements are formed via mixing a powder with water and the mixture harden through a dissolution-precipitation reaction. Today the cement mixing is performed in the operating room and consists of several complicated steps that need to be performed under sterile conditions. This renders the mixing a risk factor, potentially leading to harm for the patient e.g. unsatisfactory healing or infection. To reduce this risk, premixed cements have been developed using glycerol as mixing liquid. The premixed cement sets when it is exposed to body liquids. Therefore, premixed cement can be delivered to the operating room in prefilled syringes ready for use, thus eliminating the mixing step.

The aim of this thesis is to describe differences between premixed and water-mixed cements and their advantages and drawbacks. The differences will be discussed based on results obtained from bench testing of specific cement properties as function of cement formulations as well as in vitro and in vivo studies.

Several cement formulations were evaluated e.g. the influence of powder to liquid ratio (P/L), powder particle size and addition of water on key properties. The results showed that premixed cements have excellent handling properties and have mechanical properties similar to water-based cements. Both P/L and particle size can be used to control these properties. It was shown that small amounts of water improve certain cement properties while dry raw materials were important for long shelf life. To better understand the setting of premixed cements new methods for evaluating working time and setting of premixed cements were developed. In vivo studies showed that the formulations developed in this thesis are biocompatible, resorbable and show good tissue response in bone.

This thesis concludes, that the premixed cements are a promising biomaterial with excellent handling properties and good biological response. The most important challenge for the premixed cements, in order to become commercially successful, is to obtain clinically relevant setting time and shelf life simultaneously. An increasing use of premixed cements in the clinics should shorten operation times and reduce infection rates to the benefit of both patients and medical staff.

Place, publisher, year, edition, pages
Uppsala: Acta Universitatis Upsaliensis, 2012. 61 p.
Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, ISSN 1651-6214 ; 904
monetite, brushite, bone void filler, injecatilbity, in vivo, in vitro
National Category
Biomaterials Science Ceramics
urn:nbn:se:uu:diva-168650 (URN)978-91-554-8285-5 (ISBN)
Public defence
2012-03-29, Å2001, Ångstrsömslaboratoriet, Lägerhyddsvägen 1, Uppsala, 10:15 (English)
Available from: 2012-03-08 Created: 2012-02-14 Last updated: 2013-04-08Bibliographically approved

Open Access in DiVA

No full text

Search in DiVA

By author/editor
Åberg, Jonas
By organisation
Disciplinary Domain of Science and TechnologyFaculty of Science and TechnologyApplied Materials Sciences
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 410 hits
ReferencesLink to record
Permanent link

Direct link