uu.seUppsala University Publications
Change search
ReferencesLink to record
Permanent link

Direct link
Estimation of flank wear growth on coated inserts
Uppsala University, Disciplinary Domain of Science and Technology, Physics, Department of Physics and Astronomy.
2013 (English)Independent thesis Advanced level (degree of Master (One Year)), 20 credits / 30 HE creditsStudent thesis
Abstract [en]

The present work was conducted in Sandvik Coromant to enhance the knowledge and understanding of general flank wear growth and specifically in this case flank wear growth on the cutting edge of the coated (Ti(C, N)/ Al2O3/ TiN) tool inserts.


Reliable modeling of tool life is always a concern for machining processes. Numbers of wear models studies predicting the tool life length have been created throughout the metal-cutting history to better predict and thereby control the tool life span, which is a major portion of the total cost of machining.


A geometrical contact model defining the geometry of the flank wear growth on the cutting tool inserts was proposed and then compared with four suggested models, which estimates flank wear. The focus of this work is on the initial growth of flank wear process and thereby short cutting-time intervals are measured.


Wear tests on cutting tool inserts were performed after orthogonal turning of Ovako 825 B steel and were analysed by optical instrument, 3D optical imaging in Alicona InfiniteFocus and EDS in SEM. Force measurements for cutting speeds, Vc, 150, 200, and 250 m/min and feed rate, fn, 0.15 mm/rev were recorded as well.


Results show that initial flank wear land, VB, growth is dominated by sliding distance per cutting length for different cutting speeds. A good correlation between the geometrical contact model and estimation models is indentified. The cutting force measurements compared with the flank wear land show proportionality between two parameters. For the machining data in the present study the flank wear rate per sliding distance, dW/dL, is estimated to 2x1033/m).

Place, publisher, year, edition, pages
2013. , 55 p.
Keyword [en]
Tribology, flank wear, abrasive wear, cutting force, Cemented carbide
National Category
Materials Engineering
URN: urn:nbn:se:uu:diva-210994OAI: oai:DiVA.org:uu-210994DiVA: diva2:665068
2013-09-27, 10:00 (English)
Available from: 2013-12-09 Created: 2013-11-18 Last updated: 2013-12-09Bibliographically approved

Open Access in DiVA

fulltext(3506 kB)694 downloads
File information
File name FULLTEXT01.pdfFile size 3506 kBChecksum SHA-512
Type fulltextMimetype application/pdf

By organisation
Department of Physics and Astronomy
Materials Engineering

Search outside of DiVA

GoogleGoogle Scholar
Total: 694 downloads
The number of downloads is the sum of all downloads of full texts. It may include eg previous versions that are now no longer available

Total: 419 hits
ReferencesLink to record
Permanent link

Direct link