Logo: to the web site of Uppsala University

The POSEIDON project activities between March 2024 and February 2025 are summarized. Monte Carlo simulations show the clear advanta-ge of large CZT detectors compared to the presently used small detectors for PGET of spent nuclear fuel was demonstrated: the efficiency to detect the full energy of the gamma rays from the decay of 137Cs is more than 20 times larger. This justifies the further development of the large CZT detec-tors. The results of a first measurement campaign combining a tomogra-phic setup at Uppsala University with a detector from IDEAS in Oslo and a collimator from HIP in Helsinki demonstrates the feasibility of PGET measurements using state-of-the-art large position-sensitive CZT detec-tors, showing that such detectors are a viable choice for future develop-ment of the PGET method. This experimental work is being complemen-ted with Monte Carlo simulation of PGET of real spent nuclear fuel. First results, using a somewhat simplified gamma ray emission source, de-monstrate that the Monte Carlo framework performs well. A measurement campaign using two commercial gamma ray imagers, the CZT-based H420 and the germanium-based GeGI, in a realistic nuclear waste setup at Svafo and a real-life decommissioning situation at TSL, has resulted in valuable practical experience with both imagers. The conclusion is that both imagers perform similarly, with the H420 being somewhat easier to handle and operate. The activities have increased knowledge and exper-tise in the Northern Countries on several topics related to gamma ray imaging. A brief outlook of the continuing activities over the next year is presented.

This data set contains raw timestamped list-mode data obtained using an array of HPGe detectors for the purpose of testing coincidence spectrometry in the context of measurement on air filter samples. Data from one air-sampling station managed by the Swedish Defense Research Agency (FOI) is made available. This air-sampling station is located in Umeå, Sweden (Latitude 63.85°N, Longitude 20.34°E, 46 m above sea level). In addition to the air filter sample, data from a blank filter as well as a filter that was spiked with a known activity of radionuclides is made available in this data set. The detector setup used to collect this data set is made up of five individual HPGe detectors, with one of them surrounded by an active BGO Compton suppression shield. The data set provides a testing ground for investigating the use of multi-fold coincidence spectrometry as a tool to lower the minimum detectable activity of anthropogenic radionuclides in air filter samples. Access to this data set allows researchers to explore and evaluate analysis methodologies for coincidence γ-ray spectrometry on real samples. 

Postirradiation examination of nuclear fuel is routinely performed to characterize the important properties of current and future fuel. Gamma emission tomography is a proven noninvasive technique for this purpose. Among various measurement elements of the technique, a gamma-ray detector is an important element whose spectroscopic abilities and detection efficiency affect the overall results. Finding a combination of high detection efficiency and excellent energy resolution in a single detector is often a challenge. We have designed a novel planar segmented high-purity germanium detector that offers simultaneous measurement in six lines of sight with excellent energy resolution. The simultaneous detection ability enables faster data acquisition in a tomographic measurement, which may facilitate achieving higher spatial resolution. In this work, we have demonstrated the first use of the detector by performing a full tomographic measurement of mockup fuel rods. Two methods of detector data analysis were used to make spectra, and the images (tomograms) were reconstructed using the filtered back projection algorithm. The reconstructed images validate the successful use of the detector for tomographic measurement. The use of the detector for real fuel measurement is being planned and will be performed in the near future.

Radionuclide monitoring is a proven means of non-intrusive verification of the nuclear test ban treaty. In addition to that, the potential use of radionuclide monitoring spans beyond the detection of nuclear test explosions, since radionuclides can also be released and detected from operations of nuclear fuel cycle facilities, such as the reactor operation and nuclear reprocessing of plutonium production.

In this work, we consider the use of coincidence and anticoincidence techniques as a means to increase the sensitivity in radionuclide monitoring, in terms of improved minimum detectable amount for radionuclides of interest to filter stations used in radionuclide monitoring. In particular, a multi-detector setup is currently being prepared for the evaluation of the technique, and to provide validation data for a coincidence detector simulation codes.

In this presentation, we will describe the multi-detector setup assembled for enabling the evaluation of various types of spectrometry, including 1) gamma-gamma coincidence (from dual detectors and up to five High Purity Germanium (HPGe) detectors), 2) anticoincidence using BGO active shield with single HPGe detector, as well as use of multiple detectors in add-back mode, i.e. simply using the combined detector volume for increased efficiency of single gamma rays. We will present the results of measurements of a calibration sample, and provide a discussion on the advantages and disadvantages of the tested techniques in the context of radionuclide monitoring.

The Neutron Camera Upgrade (NCU) is a neutron flux monitor consisting of six lines of sight (LoSs) under installation on Mega Ampere Spherical Tokamak (MAST) Upgrade. The NCU is expected to contribute to the study of the confinement of fast ions and on the efficiency of non-inductive current drive in the presence of on-axis and off-axis neutral beam injection by measuring the neutron emissivity profile along the equatorial plane. This paper discusses the NCU main design criteria, the engineering and interfacing issues, and the solutions adopted. In addition, the results from the characterization and performance studies of the neutron detectors using standard gamma-rays sources and a Cf-252 source are discussed. The proposed design has a time resolution of 1 ms with a statistical uncertainty of less than 10% for all MAST Upgrade scenarios with a spatial resolution of 10 cm: higher spatial resolution is possible by moving the LoSs in-between plasma discharges. The energy resolution of the neutron detector is better than 10% for a light output of 0.8 MeVee, and the measured pulse shape discrimination is satisfactory.