Logo: to the web site of Uppsala University

This thesis deals with a system for operation of directly driven offshore wave energy converters. The work that has been carried out includes laboratory testing of a permanent magnet linear generator, wave energy converter mechanical design and offshore testing, and finally design, implementation, and offshore testing of an underwater collector substation. Long-term testing of a single point absorber, which was installed in March 2006, has been performed in real ocean waves in linear and in non-linear damping mode. The two different damping modes were realized by, first, a resistive load, and second, a rectifier with voltage smoothing capacitors and a resistive load in the DC-link. The loads are placed on land about 2 km east of the Lysekil wave energy research site, where the offshore experiments have been conducted. In the spring of 2009, another two wave energy converter prototypes were installed. Records of array operation were taken with two and three devices in the array. With two units, non-linear damping was used, and with three units, linear damping was employed. The point absorbers in the array are connected to the underwater substation, which is based on a 3 m³ pressure vessel standing on the seabed. In the substation, rectification of the frequency and amplitude modulated voltages from the linear generators is made. The DC voltage is smoothened by capacitors and inverted to 50 Hz electrical frequency, transformed and finally transmitted to the on-shore measuring station. Results show that the absorption is heavily dependent on the damping. It has also been shown that by increasing the damping, the standard deviation of electrical power can be reduced. The standard deviation of electrical power is reduced by array operation compared to single unit operation. Ongoing and future work include the construction and installation of a second underwater substation, which will connect the first substation and seven new WECs.

A wave energy converter has been constructed and its function and operational characteristics have been thoroughly investigated and published. The wave energy converter was installed in March of 2006 approximately two kilometers off the Swedish west coast in the proximity of the town Lysekil. Since then the converter has been submerged at the research site for over two and a half years and in operation during three time periods for a total of 12 months, the latest being during five months of 2008. Throughout this time the generated electricity has been transmitted to shore and operational data has been recorded. The wave energy converter and its connected electrical system has been continually upgraded and each of the three operational periods have investigated more advanced stages in the progression toward grid connection. The wave energy system has faced the challenges of the ocean and initial results and insights have been reached, most important being that the overall wave energy concept has been verified. Experiments have shown that slowly varying power generation from ocean waves is possible.

Apart from the wave energy converter, three shorter studies have been performed. A sensor was designed for measuring the air gap width of the linear generator used in the wave energy converter. The sensor consists of an etched coil, a search coil, that functions passively through induction. Theory and experiment showed good agreement.

The Swedish west coast wave climate has been studied in detail. The study used eight years of wave data from 13 sites in the Skagerrak and Kattegatt, and data from a wave measurement buoy located at the wave energy research site. The study resulted in scatter diagrams, hundred year extreme wave estimations, and a mapping of the energy flux in the area. The average energy flux was found to be approximately 5.2 kW/m in the offshore Skagerrak, 2.8 kW/m in the near shore Skagerrak, and 2.4 kW/m in the Kattegat.

A method for evaluating renewable energy technologies in terms of economy and engineering solutions has been investigated. The match between the technologies and the fundamental physics of renewable energy sources can be given in terms of the technology’s utilization. It is argued that engineers should strive for a high utilization if competitive technologies are to be developed.

Surface gravity waves in the world’s oceans contain a renewable source of free power on the order of terawatts that has to this date not been commercially utilized. The division of Electricity at Uppsala University is developing a technology to harvest this energy. The technology is a point absorber type wave energy converter based on a direct-driven linear generator placed on the sea bed connected via a line to a buoy on the surface.

The work in this thesis is focused mainly on the energy transport of ocean waves and on increasing the transfer of energy from the waves to the generator and load. Potential linear wave theory is used to describe the ocean waves and to derive the hydrodynamic forces that are exerted on the buoy. Expressions for the energy transport in polychromatic waves travelling over waters of finite depth are derived and extracted from measured time series of wave elevation collected at the Lysekil test site. The results are compared to existing solutions that uses the simpler deep water approximation. A Two-Body system wave energy converter model tuned to resonance in Swedish west coast sea states is developed based on the Lysekil project concept. The first indicative results are derived by using a linear resistive load. The concept is further extended by a coupled hydrodynamic and electromagnetic model with two more realistic non-linear load conditions.

Results show that the use of the deep water approximation gives a too low energy transport in the time averaged as well as in the total instantaneous energy transport. Around the resonance frequency, a Two-Body System gives a power capture ratio of up to 80 percent. For more energetic sea states the power capture ratio decreases rapidly, indicating a smoother power output. The currents in the generator when using the Two-Body system is shown to be more evenly distributed compared to the conventional system, indicating a better utilization of the electrical equipment. Although the resonant nature of the system makes it sensitive to the shape of the wave spectrum, results indicate a threefold increase in annual power production compared to the conventional system.