Logo: to the web site of Uppsala University

uu.sePublications from Uppsala University
Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
SO2 adsorption on rutile TiO2(110): An infrared reflection-absorption spectroscopy and density functional theory study
Uppsala University, Disciplinary Domain of Science and Technology, Technology, Department of Materials Science and Engineering, Solid State Physics.ORCID iD: 0000-0001-9589-7073
Uppsala University, Disciplinary Domain of Science and Technology, Chemistry, Department of Chemistry - Ångström, Structural Chemistry.ORCID iD: 0000-0003-3570-0050
Uppsala University, Disciplinary Domain of Science and Technology, Chemistry, Department of Chemistry - Ångström, Structural Chemistry.
Uppsala University, Disciplinary Domain of Science and Technology, Technology, Department of Engineering Sciences, Solid State Physics.ORCID iD: 0000-0003-0296-5247
2018 (English)In: Surface Science, ISSN 0039-6028, E-ISSN 1879-2758, Vol. 677, p. 46-51Article in journal (Refereed) Published
Abstract [en]

The adsorption of SO2 on single crystalline TiO2(110) has been investigated by means of polarized infrared reflection-absorption spectroscopy (IRRAS) experiments and density functional theory (DFT) calculations. IR absorption bands were detected at 1324 cm-1 and 985 cm-1 with p-polarized light incident along both the [110] and [001] crystallographic directions at 123 K. When the temperature was increased to 153 K, the peak at 1324 cm-1 disappears, while a new, weak band appears at 995 cm-1. Simultaneously, a band at 995 cm-1 also emerges with s-polarized light along the [110] direction. Based on the symmetry properties of the IRRAS spectra and accompanying ab initio simulations of the spectra employing a three layer model (vacuum-adsorbate-substrate), it is shown that the low temperature absorption IRRAS bands can be attributed to an SO3-like adsorbate structure. This is also the most stable adsorption structure (Ead = - 0.58 eV) on the stoichiometric surface. The combined IRRAS and DFT results show that the band appearing at 995 cm-1 is associated with a surface sulfite specie which is stabilized by residual surface water. The DFT calculations also revealed that a stable adsorption structure exists on a reduced TiO2 surface, where SO2 binds strongly to an oxygen vacancy site. It is suggested that this is an intermediate that form surface sulfate upon further reactions with water, although it was not observed on the stoichiometric surface studied in this work.

Place, publisher, year, edition, pages
Elsevier, 2018. Vol. 677, p. 46-51
Keywords [en]
SO2, TiO2(110), SO3, Infrared reflection absorption spectroscopy, Density functional theory
National Category
Engineering and Technology
Research subject
Engineering Science with specialization in Solid State Physics
Identifiers
URN: urn:nbn:se:uu:diva-369047DOI: 10.1016/j.susc.2018.05.016ISI: 000447478700008OAI: oai:DiVA.org:uu-369047DiVA, id: diva2:1270263
Funder
Swedish Research Council, 2015 -04757Available from: 2018-12-12 Created: 2018-12-12 Last updated: 2022-11-17Bibliographically approved
In thesis
1. Adsorption and reactions of sulfur dioxide on TiO2 surfaces: Fundamental studies on single crystals and nanoparticles
Open this publication in new window or tab >>Adsorption and reactions of sulfur dioxide on TiO2 surfaces: Fundamental studies on single crystals and nanoparticles
2019 (English)Licentiate thesis, comprehensive summary (Other academic)
Abstract [en]

Titanium dioxide (TiO2) is a material that is well-known among researchers in environmental science but is perhaps less well-known by the general public. It is commonly used in white paint because of its ability to scatter visible light, and for this reason it is manufactured at a large industrial scale. This is not the reason it has become famous, however, although the large abundance makes it interesting for use in industrial applications. It is famous for its ability to catalyze chemical reactions through the absorption of light. This process is called photocatalysis and it enables both uphill (photosynthetic) and downhill (photocatalytic) reactions since energy is transferred to the reacting molecules during the light absorption. The generation of H2gas from water and the formation of methane or methanol from carbon dioxide and water are two examples of photosynthetic reactions that are possible using TiO2. It can also be used for the degradation of pollutants, toxic compounds and bacteria, as well as for a number of technological applications, such as self-cleaning windows, solar cells and air purification filters.

This thesis work has primarily been focused on investigating the surface properties of TiO2and its interaction with sulfur dioxide (SO2). Single crystalline rutile TiO2(110) has been used as a model surface to study fundamental surface interactions with SO2by infrared reflection-absorption spectroscopy (IRRAS). This is a technique that can measure the type of species adsorbed on a surface and also its adsorbate structure. This is achieved by reflecting linearly polarized infrared light from a surface at different azimuth angles and comparing the signal intensity after adsorption. The molecules will then couple differently with the reflected light depending on the incident azimuth angle and the type of polarization used, which gives information about how the molecules are oriented on the surface. Work has also been done to study the structural modifications of TiO2nanoparticles after reduction through vacuum annealing. The induced changes of the crystal structure and lattice vibrations have been measured with X-ray diffraction and Raman spectroscopy, while the surface chemical properties have been studied via the adsorption of SO2. This was used as a probe molecule to detect the presence of surface defects, since SO2is known to react at defect sites while not binding to the stoichiometric surface at room temperature. The photo-reaction of SO2during UV illumination was also for the first time studied in an oxygen-free atmosphere. 

This work has provided new information about the fundamental surface interactions of SO2with single crystalline rutile TiO2(110). It has also provided valuable information about the defect distribution in reduced TiO2nanoparticles after preparation by vacuum annealing.

Place, publisher, year, edition, pages
Uppsala: Uppsala universitet, 2019. p. 71
National Category
Other Materials Engineering
Identifiers
urn:nbn:se:uu:diva-379974 (URN)
Presentation
2019-04-12, 2005, Ångström, Lägerhyddsvägen 1, 751 21, Uppsala, 10:15 (English)
Opponent
Supervisors
Available from: 2019-03-28 Created: 2019-03-21 Last updated: 2019-03-28Bibliographically approved
2. Capturing Air Pollutants: Photochemical Adsorption and Degradation of SO2, NO2 and CO2 on Titanium Dioxide
Open this publication in new window or tab >>Capturing Air Pollutants: Photochemical Adsorption and Degradation of SO2, NO2 and CO2 on Titanium Dioxide
2021 (English)Doctoral thesis, comprehensive summary (Other academic)
Abstract [en]

Titanium dioxide (TiO2) is a material with many useful properties. It is used most widely as a pigment in white paint, although in technological research it is better known for its ability to catalyze chemical reactions during light absorption. This process is referred to as photocatalysis, where the energy of the light is used to power the chemical reactions. This has enabled several interesting applications of TiO2, where it can for instance be applied to windows or façade walls to make their surfaces self-cleaning. Another implementation that has received much attention lately is artificial photosynthesis, where the light energy is used to transform CO2 and H2O into synthetic fuels. This thesis work contributes to the development of both these applications, although the main ambition is to show how three of the most common ambient air pollutant molecules, SO2, NO2 and CO2, can be captured at the surface of TiO2 by means of photocatalysis. 

Specifically, infrared (IR) spectroscopy and density functional theory (DFT) has been used as complementary tools of analysis to study the photocatalytic reactions that enable transformation of SO2, NO2 and CO2 into strongly bound sulfates, nitrates and carbonates, respectively. This combined experimental and theoretical approach has enabled a detailed description of how these reactions proceed and has further shown how the fundamental reactivity of the TiO2 surface changes upon light absorption.

The work presented herein contributes to an increased understanding of photocatalysis and shows, quite generally, how molecules can be effectively captured at the surface of metal oxides by forming surface-integrated ionic adsorbates.

Place, publisher, year, edition, pages
Uppsala: Acta Universitatis Upsaliensis, 2021. p. 103
Series
Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, ISSN 1651-6214 ; 2012
Keywords
titanium dioxide, photocatalysis, surface reaction, oxygen vacancies, air pollution, sulfur dioxide, nitrogen dioxide, carbon dioxide, sulfate, nitrate, carbonate
National Category
Engineering and Technology Materials Engineering Chemical Engineering Natural Sciences Physical Sciences Chemical Sciences
Research subject
Engineering Science with specialization in Solid State Physics
Identifiers
urn:nbn:se:uu:diva-434258 (URN)978-91-513-1136-4 (ISBN)
Public defence
2021-03-26, Room Å2001, Ångströmlaboratoriet, Lägerhyddsvägen 1, Uppsala, 13:15 (English)
Opponent
Supervisors
Available from: 2021-03-02 Created: 2021-02-07 Last updated: 2022-05-05Bibliographically approved

Open Access in DiVA

No full text in DiVA

Other links

Publisher's full text

Authority records

Langhammer, DavidKullgren, JollaMitev, Pavlin D.Österlund, Lars

Search in DiVA

By author/editor
Langhammer, DavidKullgren, JollaMitev, Pavlin D.Österlund, Lars
By organisation
Solid State PhysicsStructural ChemistrySolid State Physics
In the same journal
Surface Science
Engineering and Technology

Search outside of DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric score

doi
urn-nbn
Total: 310 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf